How do you tighten the screws on a Tech Deck?

Create a hole in the center of a pencil eraser using a thumbtack or push-pin. Use the pencil as a wrench to tighten the nuts which hold the wheel to the axle. As the nut tightens and reveals the axle, let the axle slide into the hole you created with the push-pin.

How do you set up a Tech Deck?

0:053:32HOW TO SETUP A FINGERBOARD - YouTubeYouTubeStart of suggested clipEnd of suggested clipSecond to keep everything together you need your trucks. And using block fill the trucks are a twoMoreSecond to keep everything together you need your trucks. And using block fill the trucks are a two millimeter.

How do you use a Tech Deck holder?

0:261:47Tech Deck Tutorials: Getting Started - YouTubeYouTubeStart of suggested clipEnd of suggested clipJust push down on your middle finger to pop the board up and snap your wrist at the same time. ItsMoreJust push down on your middle finger to pop the board up and snap your wrist at the same time. Its a delicate move so stay with it dude.

How do you remove a Tech Deck truck?

1:558:32HOW TO TAKE THE TRUCKS AND KINGPINS OFF YOUR TECHDECK YouTube

How do you put griptape on a Tech Deck?

0:411:45Tech Deck Trick Tape - Getting Started - YouTubeYouTube

How do you put trucks on a Tech Deck?

1:136:56how to put trucks on a Fingerboard - YouTubeYouTube

How can I make my griptape grippy again?

3:104:35Clean Skateboard & Longboard Grip Tape - YouTubeYouTube

How do you take apart a Tech Deck?

0:484:16How to take apart a tech deck and put it back together - YouTubeYouTube

How do you take trucks off a Tech Deck?

1:518:32HOW TO TAKE THE TRUCKS AND KINGPINS OFF YOUR TECHDECK YouTube