Question: Why are there 2 holes in the skimmer?

The second hole in the skimmer is connected to a pipe called an equalizer. It prevents the pump from taking in air if the pools water level dips below the skimmer opening. If the pool water is low the pump pulls water from the equalizer line so the pump doesnt run dry.

How do I adjust the skimmer suction on my pool?

You can do this by exerting pressure in the pipe in the opposite direction to the suction. This can be done by connecting a hose or an air compressor, which will send water (or air) into the skimmer with enough force to remove the clog. Caution: These operations require more or less complex assemblies.

Should skimmer valve be open or closed?

For the cleaner to operate at maximum efficiency, only the skimmer and cleaner valves should be open. No other valves should be open. So it is either main drain+skimmer or cleaner+skimmer. Never main drain+skimmer+cleaner all open at the same time.

What is the purpose of a skimmer door?

A skimmers primary function is to pull water into the system with a skimming action, which means it pulls in dirt, oil, leaves, twigs, and debris hopefully before they can fall to the bottom of the pool. A skimmer also provides a conveniently located suction line for vacuuming.

How does a pool skimmer diverter work?

1:1911:24Pool Skimmer Diverters - YouTubeYouTubeStart of suggested clipEnd of suggested clipGoes directly to the pump its the suction that sucks directly into the pump okay the other one goesMoreGoes directly to the pump its the suction that sucks directly into the pump okay the other one goes down to the floor drain.

What setting should your pool filter be on when vacuuming?

For routine vacuuming, the filter valve is left in the normal “Filter” position. This directs dirty vacuum water through the pool filter to remove the contaminants, then conveys filtered water through return lines back to the pool. The Filter setting is used for light to moderate levels of pool sediment.

What happens if the water is above the skimmer?

When your pool water levels exceed the middle part of your pools skimmer, your skimmer is not going to work properly. The water flows into the skimmer at a higher level, it causes the water to not get skimmed properly.

Why does my skimmer door get stuck?

When the pool is off the door of the skimmer then closes, covering the opening which causes debris to stay in the skimmer. If the water level is too high the floating weir is too short to stay in the opening of basket and it gets stuck sideways which blocks the skimmer.

Do I need a skimmer diverter valve?

Using a diverter plate allows you to choose whether the water is sent to your pools pump and filter or to the main drain line. If you have multiple skimmers for your pool, diverter plates can help you adjust the amount of water being suctioned by each one. Diverter plates are necessary when you use a pool vacuum.

How do you know if your skimmer is working properly?

If air is being properly mixed with the water your skimmer should be producing bubbles. If your skimmer is producing bubbles then chances are there is nothing wrong with your skimmer. It may just need to break in, be cleaned, or be readjusted.

Can you run pool filter if water is above skimmer?

Your pool skimmer will help filter out some debris and insects that enter your pool, but only if the water level isnt above the skimmer opening. If the skimmer is completely covered by water, then it wont work properly.

Join us

Find us at the office

Heston- Cat street no. 49, 44572 Yerevan, Armenia

Give us a ring

Kaeli Mastroddi
+51 487 505 696
Mon - Fri, 8:00-19:00

Contact us